button instead of switch

[bmosley]

my controls are push button based. press once, light goes on, press again, light goes off.
is there a way to change it to mirror that behavior for the HomeKit UI?

With Switches, if i set duration, it works correctly, but HomeKit shows the switch is OFF instead of it's actual ON state.

[rsg98]

There isn’t a way at the moment - am planning on adding a stateful programmable Switch to the v2 that’s currently up in alpha... That will allow you to use another GPIO line as a state sensing input, which I think will perform as you describe (with the bonus that the on/off shouldn’t get out of sync with reality, because of the feedback loop) Not going to be able to work on this for a while, as I’m away, but the outline of support for this type of config is in the v2.0.0-alpha branch.

…

On Thu, 21 Sep 2017 at 08:47, Bryan ***@***.***> wrote: my controls are push button based. press once, light goes on, press again, light goes off. is there a way to change it to mirror that behavior for the HomeKit UI? With Switches, if i set duration, it works correctly, but HomeKit shows the switch is OFF instead of it's actual ON state. — You are receiving this because you are subscribed to this thread. Reply to this email directly, view it on GitHub <#33>, or mute the thread <https://github.com/notifications/unsubscribe-auth/ARe_tdhaF-VaQvL8M2jmzZVhmuYfdCtrks5skhSXgaJpZM4Pe7Yl> .

[kiondi]

I have the same problem, we wait your new great job, ;)