Modem Signals (Snapdragon X75)

[KFOq]

Reopen subject :

Hi Dear Sir IceG

After doing this command (advised by IceG)

root@OpenWrt:~# cp /usr/share/3ginfo-lite/modem/usb/0e8d7126 /usr/share/3ginfo-lite/modem/usb/2cb70104
When network connected to 4G only the signal appeared .

Note: its showing only one band 4G , where there are more than 4 bands 4G

After I switched the network to 5G NSA (4G+5G) .... The error came again .

AT commands file for these modems (which is same command mostly)

• FM190 Series &FG190 Series (X75 modem)
• FG370 Series (Meditek modem)

Fibocom_AT Commands 2025 MBB_V2.4.pdf

I tried this but I think I didn't do right or the scripts on package is not matching with modem

@ghost I don't know if it will work, but you can check it out.
Unpack test.zip archive and copy files to usr/share/3ginfo-lite/modem/usb.

Hi Boss I tested your package it was not working as I know ... maybe there is something wrong with my setup or the package doesn't match with modem FM190W-GL

---

Please in same time can you take look for these points :

• Can you add RSRP for 5G bands for modems like RM520 or RM551 "both same at command" ? (to be added after mhz maybe you can do it for all 4g and 5g

• Can you increase the limit of CA cells that showing in interface (limited only CA band SCC4).... because in my case I have 5 bands 4G and 2 bands 5G NSA .... its better to make it up to band (SCC7)