Load Balancing Options

Load Balancing

dnscrypt-proxy comes with a load balancing algorithm. It will send consecutive DNS queries to different DNS servers randomly choosen from a sorted (fastest to slowest) set of a choosen size. The size of that set is what you can choose in the configuration file with the lb_strategy parameter. A server will be choosen randomly among the N fastest servers in your list of servers (or if you are not specifically choosing servers with the server_names parameter, among the N fastest servers from all servers that match your requirements.)

How The List Of Servers Is Populated

When dnscrypt-proxy:

• Starts
• Each time the server certificates (for DNSCrypt servers) are retrieved/validated (every cert_refresh_delay minutes)
• Each time the list of servers is retrieved (every refresh_delay hours)

It calculates an initial RTT (Round-Trip Time) estimation for each resolver (for DoH servers, two initial test queries are made). This list is then sorted from fastest to slowest resolver.

How the servers are sorted

dnscrypt-proxy keeps the list of servers sorted at all times.

Each time a query is made to a server, the time it takes is used to adjust how fast dnscrypt-proxy thinks that the server is, using an exponentially weighted moving average. If the newly adjusted RTT of the resolver that was just used happens to be bigger (slower) than a randomly choosen candidate from the list of all servers, then these entries are swapped.

Over time, every server gets compared to all other servers and the list is progressively kept sorted. Slow servers will probably never compare favorably with the fast servers and will remain at the bottom of the list. Since response times vary appreciably even for the same server, especially as DNS servers need to query other servers to resolve domains when they are not in the cache, the servers at the top of the list might move around as time goes by even if they are close to you.

Load-balancing options

So, the servers are sorted from quickest to slowest. The load balancing is done using that list. You have a choice of 4 different ranges/sets from which to choose the server that will next be queried. The server is choosen randomly inside that set. The 4 possible values of the lb_strategy parameter are:

• first (always pick the fastest server in the list)
• p2 (randomly choose between the top 2 fastest servers)
• ph (randomly choose between the top fastest half of all servers)
• random (just pick any random server from the list)

This setting is a string, so you use lb_strategy = 'p2' in the configuration file.

The default strategy is p2 so dnscrypt-proxy will pick one of the two fastest servers. It will compare how fast that server was with a randomly choosen server and if that random server is faster, the random server will move up. The same is true for all strategies - random servers will move up in the list when they are faster than the server that was just queried.

Notes

If you enable logging and have a look at the dnscrypt-proxy log, you will see the response times of all your servers when the proxy starts. You should notice that only a few servers are very fast for you, with the majority being appreciably slower.

What this means is that if you have a relatively large list of random servers from around the world, and you choose the ph strategy, some of your queries will probably end-up using slower servers; p2 is probably the best strategy to use.

However, ph would be pretty good if you were choosing regular DNS servers, since there are thousands of those and many would be very fast for you (you can easily find 50 fast servers for any location in North-America).