Skip to content

Latest commit

 

History

History
72 lines (52 loc) · 2.83 KB

3328-G.md

File metadata and controls

72 lines (52 loc) · 2.83 KB
title description addedAt pageClass
Centralite 3328-G control via MQTT
Integrate your Centralite 3328-G via Zigbee2MQTT with whatever smart home infrastructure you are using without the vendor's bridge or gateway.
2021-08-01 20:41:55 UTC
device-page

Centralite 3328-G
Model 3328-G
Vendor Centralite
Description 3-Series micro motion sensor
Exposes occupancy, battery_low, tamper, temperature, linkquality
Picture Centralite 3328-G

Options

How to use device type specific configuration

  • temperature_calibration: Calibrates the temperature value (absolute offset), takes into effect on next report of device. The value must be a number.

  • temperature_precision: Number of digits after decimal point for temperature, takes into effect on next report of device. This option can only decrease the precision, not increase it. The value must be a number with a minimum value of 0 and with a with a maximum value of 3

Exposes

Occupancy (binary)

Indicates whether the device detected occupancy. Value can be found in the published state on the occupancy property. It's not possible to read (/get) or write (/set) this value. If value equals true occupancy is ON, if false OFF.

Battery low (binary)

Indicates if the battery of this device is almost empty. Value can be found in the published state on the battery_low property. It's not possible to read (/get) or write (/set) this value. If value equals true battery low is ON, if false OFF.

Tamper (binary)

Indicates whether the device is tampered. Value can be found in the published state on the tamper property. It's not possible to read (/get) or write (/set) this value. If value equals true tamper is ON, if false OFF.

Temperature (numeric)

Measured temperature value. Value can be found in the published state on the temperature property. It's not possible to read (/get) or write (/set) this value. The unit of this value is °C.

Linkquality (numeric)

Link quality (signal strength). Value can be found in the published state on the linkquality property. It's not possible to read (/get) or write (/set) this value. The minimal value is 0 and the maximum value is 255. The unit of this value is lqi.