EthernetPHY.ucf

##
## =============================================================================================================================================================
## Ethernet PHY - Marvell Alaska Ultra
## =============================================================================================================================================================
##	Bank:						3, 11, 22
##		VCCO:					2.5V (VCC2V5_FPGA), 2.5V (VCC2V5_FPGA), 3.3V (VCC3V3_FPGA)
##	Location:				U16
##		Vendor:				Marvell
##		Device:				M88E1111 -
##		MDIO-Address:	0x05 (---0 0111b)
##		I²C-Address:	I²C management mode is not enabled
##		Configuration:	set J20 to 3-5 and 4-6 to select 2.5 V for VCCO_EXP (Bank 11 and 13)
##										set J22 to 1-2 for MII/GMII interface
##										set J23 to 1-2 for MII/GMII interface
##										set J24 = OFF to disable RGMII
##
## common signals and management
## --------------------------
NET "ML505_EthernetPHY_Reset_n"									LOC = "J14" | IOSTANDARD = LVCMOS25; ## {IN}			U16.36; Bank 3; no DCI
NET "ML505_EthernetPHY_Interrupt_n"							LOC = "H20" | IOSTANDARD = LVCMOS25; ## {IN}			U16.32; Bank 3; no DCI
NET "ML505_EthernetPHY_Management_Clock"				LOC = "H19" | IOSTANDARD = LVCMOS25; ## {OUT}			U16.35; Bank 3; no DCI
NET "ML505_EthernetPHY_Management_Data"					LOC = "H13" | IOSTANDARD = LVCMOS25; ## {INOUT}		U16.33; Bank 3; no DCI

## Ignore timings on async I/O pins
NET "ML505_EthernetPHY_Reset_n"									TIG;
NET "ML505_EthernetPHY_Interrupt_n"							TIG;
NET "ML505_EthernetPHY_Management_*"						TIG;