Build for Portisch firmware

[nordeep]

Not issue at all! Just saying thank you for your work at this project!
Due to your work, I was able add A-OK protocol to Sonoff RF Bridge Portisch firmware. I have post Pull request to maintainer, unfortunately, project seems is not updating. If anyone inertsting .hex build of Portisch firmware available in my fork.

[akirjavainen]

Thank you and awesome to hear this project has helped you! I'll take a look at that pull request. :)

[joeH68]

Hi, 1,5 years later I have a similar need. Would like to simulate/replace A-OK AC123-01D remote control with a Sonoff RF Bridge and Portisch FW. Did you get this approach to work? Is there a build/fork I may try? Thanks!

[nordeep]

Hi! You could check .hex build file in my fork https://github.com/nordeep/RF-Bridge-EFM8BB1/blob/master/Keil%208051%20v9.53%20-%20Release/RF-Bridge-EFM8BB1.hex

[joeH68]

thanks! unfortunately I'm not a fw developer. What am I supposed to do with the file?

[nordeep]

It's good place to start - https://tasmota.github.io/docs/devices/Sonoff-RF-Bridge-433/

[joeH68]

Ok, I see. I will flash it and try. Thanks

[joeH68]

Got it flashed. Existing RF sensors all recognized and running. Next week I'll try A-OK remote control.
Thanks!

[joeH68]

@nordeep thanks for your excellent work and support! Following your instructions and those in [https://tasmota.github.io/docs/devices/Sonoff-RF-Bridge-433/] I was able to:

• flash your modified firmware https://github.com/nordeep/RF-Bridge-EFM8BB1/blob/master/Keil%208051%20v9.53%20-%20Release/RF-Bridge-EFM8BB1.hex
• sniff the 'B1' codes of my A-OK AC123-01D remote control
• use the "online converter" to convert sniffed B1 messages to the 'B0' format required in the RfRaw command
• use MQTT to submit RfRaw command

Pending is the confirmation that the commands are actually working on the blinds as I'm currently offsite.