How to calculate veer distance for bata V3.6

[Kelv68]

For the new Veer block/code, do you know a way to calculate the mm. I figured out the radius part

But i want to know if there's any calculation for the "by()mm", so it's quicker to do, than just testing it every time?

[ggramlich]

I am not quite sure, what kind of formula you are looking for, but these two blocks (veer and curve) result in the same motion: Both do a full circle.

This is not taking into account the directions when using a negative value for radius.

If you know the distance on the arc that you want to drive, use veer. If you know the angle you want to drive, use curve.

Maybe you can give an example of what you want to achieve.

[laurensvalk]

I would use a measuring tape to estimate how far you want to drive.

The veer method was specifically added so you could do that, without having to calculate the arc angle yourself.