-
Notifications
You must be signed in to change notification settings - Fork 407
Updating Firmware
The PortaPack has its own firmware, which needs to be flashed into the HackRF One SPI flash.
You will need a few tools installed on your computer before you begin.
- dfu-util 0.7 or 0.8 - Used to load and run the stock HackRF firmware from RAM. dfu-util 0.7 is recommended, as it is the most extensively tested with the HackRF hardware and build software.
- hackrf - All you need is the host tools, specifically, hackrf_spiflash.
You may download a released firmware package, a continuous integration build of the latest firmware or build your own firmware.
If you downloaded the pre-built package, change directories to where you unzipped or untarred/unbzipped the package.
If you built your own firmware, the files you need are in the firmware/ subdirectory of your local portapack-hackrf repository.
You will need two files: hackrf_one_usb_ram.dfu, which is the stock HackRF firmware, which provides a means to program the SPI flash. The SPI flash will be programmed with the second file, called portapack-h1-firmware.bin.
To install the firmware into the HackRF's SPI flash, hold down the HackRF's DFU button (the button closest to the antenna jack) and plug the HackRF into a USB port on your computer. After the HackRF is plugged in, you may release the DFU button.
Use the DFU utility to download the hackrf_one_usb_ram.dfu image file into the HackRF:
dfu-util --device 1fc9:000c --download hackrf_one_usb_ram.dfu --reset
Then, erase the HackRF SPI flash and write the PortaPack code into SPI flash:
hackrf_spiflash -w portapack-h1-firmware.bin
Unplug your HackRF from your computer, wait a few seconds, and plug it back in. You should now be running PortaPack code.
NOTE: If you have never updated your HackRF CPLD bitstream, you might also want to do that now, as advised under "Updating the CPLD" on the HackRF Wiki. There was a change around April 2014 that is required for PortaPack and newer gr-osmosdr host libraries. If the HackRF CPLD bitstream is old, you may encounter odd behavior -- frequencies being a few MHz off, and lots of baseband harmonic distortion.
Download the HackRF firmware from the HackRF project's releases section. Extract the release archive and change directories into the archive. Then change directories into firmware-bin:
cd firmware-bin
Plug the HackRF into USB power while holding down the DFU button (the button closest to the antenna jack). Release the DFU button. Then run:
dfu-util --device 1fc9:000c --download hackrf_one_usb_ram.dfu --reset
The HackRF firmware is now running from the microcontroller's RAM. Do not reset the HackRF at this point. Flash the HackRF firmware thusly:
hackrf_spiflash -w hackrf_one_usb_rom_to_ram.bin
Once this command completes, you may either unplug the HackRF or press the RESET button, and the HackRF firmware will run from the flash memory.
- Diagram of DFU button location