Skip to content

Latest commit

 

History

History
91 lines (59 loc) · 3.55 KB

README.md

File metadata and controls

91 lines (59 loc) · 3.55 KB

Exercise 7 - Istio Ingress Controller

NOTE: If you are using Minikube, this section may not work. However there are other approaches to access the service such as using telepresence.

The components deployed on the service mesh by default are not exposed outside the cluster. External access to individual services so far has been provided by creating an external load balancer on each service.

Traditionally in Kubernetes, you would use an Ingress to configure a L7 proxy. However, Istio provides a much richer set of proxy configurations that are not well-defined in Kubernetes Ingress. Thus, in Istio, we will use Isito Gateway to define fine grained control over L7 edge proxy configuration.

Inspecting the Istio Ingress Gateway

The ingress controller gets expossed as a normal Kubernetes service load balancer:

kubectl get svc istio-ingressgateway -n istio-system -o yaml

Find the IP address of the Ingress Gateway:

export INGRESS_IP=$(kubectl -n istio-system get service istio-ingressgateway -o jsonpath='{.status.loadBalancer.ingress[0].ip}')
echo $INGRESS_IP

curl the IP address:

curl http://$INGRESS_IP

This will return connection refused error. That is because there are no gateway configured to listen to any incoming connections.

Configure Guestbook Ingress

1 - Create a new Gateway

kubectl apply -f istio/guestbook-gateway.yaml

There is a selector block in the gateway definition. The selector will be used to find the actual edge proxy that should be configured to accept traffic for the gateway. This example selects pods from any namespaces that has the label of istio and value of ingressgateway.

This is similar to running:

kubectl get pods -l istio=ingressgateway --all-namespaces

You'll find a single pod that matches this label, which is the Ingress Gateway that we looked at earlier.

NAMESPACE      NAME                                    READY     STATUS    RESTARTS   AGE
istio-system   istio-ingressgateway-...                1/1       Running   0          7d

After creating the Gateway, it'll enable the Istio Ingress Gateway to listen on port 80. The hosts block of the configuration can be used to configure virtual hosting. E.g., the same IP address can be configured to respond to different host names with different routing rules.

If you curl the ingress IP again:

curl -v http://$INGRESS_IP

Rather than connection refused, you should see the server responded with 404 Not Found HTTP response. This is because we have not bound any backends to this gatway yet.

2 - Create a Virtual Service

To bind a backend to the gateway, we'll need to create a virtual service.

kubectl apply -f istio/guestbook-ui-vs.yaml

A virtual service is a logical grouping of routing rules for a given target service. For ingress, we can use virtual service to bind to a gateway.

This example binds the to the gateway we just created, and will respond to any hostname. Again, if you need to use virtual hosting and respond to different host names, you can specify them in the hosts section.

3 - Connect via the Ingress Gateway

Try connecting to the Ingress Gateway again.

curl http://$INGRESS_IP

This time you should see the HTTP response!

4 - Browse to the Guestbook UI using the Ingress Gateway IP address.

5 - Try Hello a few times

In the browser, say hello a couple of times, and you'll see that the greeting reply will round robin between v1 and v2 versions of the hello service.

Exercise 8 - Telemetry