Skip to content
New issue

Have a question about this project? # for a free GitHub account to open an issue and contact its maintainers and the community.

#

By clicking “#”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.

Already on GitHub? # to your account

Add setoption68 detail #1443

Merged
merged 1 commit into from
Jan 1, 2025
Merged

Add setoption68 detail #1443

Changes from all commits
Commits
Show all changes
1 commit
Select commit
File filter

Filter by extension

Filter by extension
Conversations
Failed to load comments.
Loading
Jump to
Jump to file
Failed to load files.
Loading
Diff view
Diff view
1 change: 1 addition & 0 deletions docs/Commands.md
View file
Open in desktop
Original file line number Diff line number Diff line change
Expand Up @@ -566,6 +566,7 @@ SetOption63<a class="cmnd" id="setoption63"></a>|Set relay state feedback scan a
SetOption64<a class="cmnd" id="setoption64"></a>|Switch between `-` or `_` as sensor name separator<BR>`0` = sensor name index separator is `-` _(hyphen)_ *(default)*<BR> `1` = sensor name index separator is `_` _(underscore)_<br>*Affects DS18X20, DHT, BMP and SHT3X sensor names in tele messages*
SetOption65<a class="cmnd" id="setoption65"></a>|Device recovery using [fast power cycle detection](Device-Recovery.md#fast-power-cycle-device-recovery)<BR>`0` = enabled *(default)*<BR>`1` = disabled
SetOption66<a class="cmnd" id="setoption66"></a>|Set publishing TuyaReceived to MQTT<BR>`0` = disable publishing `TuyaReceived` over MQTT *(default)*<BR>`1` = enable publishing `TuyaReceived` over MQTT
SetOption68<a class="cmnd" id="setoption68"></a>|See Light->MultiPWM
SetOption69<a class="cmnd" id="setoption69"></a>|Invert Serial receive on SerialBridge<BR>In older versions: **Deprecated** in favor of [DimmerRange](#dimmerrange) <br>By default Tuya dimmers won't dim below 10% because some don't function very well that way.<BR>`0` = disable Tuya dimmer 10% lower limit<BR>`1` = enable Tuya dimmer 10% lower limit *(default)*
SetOption71<a class="cmnd" id="setoption71"></a>|Set DDS238 Modbus register for active energy<BR>`0` = set primary register *(default)*<BR>`1` = set alternate register
SetOption72<a class="cmnd" id="setoption72"></a>|Set reference used for total energy <BR>`0` = use firmware counter *(default)*<BR>`1` = use energy monitor (e.g., PZEM-0xx, SDM120, SDM630, DDS238, DDSU666) hardware counter
Expand Down
Loading