This repository has been archived by the owner on Mar 2, 2024. It is now read-only.
Radio Connections
The XTL odyssey heads are annoying - the rear aux mic pin is only enabled with a rear PTT, which cannot be emulated via SB9600. Therefore, TX audio has to come through the mic connection on the head itself. Therefore, only the dash mount configuration is supported. To use XTLs in a headless configuration, you must configure the radio as a W9 head.
- SB9600 RIB
- Bidirectional Soundcard (Speaker & Mic Connections)
J2 Accessory Connector (Rear)
Mobile Microphone Port (Front)
TX Audio - Front MMP (Mobile Mic Port) Connector
| Pin | Description | Soundcard Connection |
|---|---|---|
| 5 | Ground | Ground |
| 7 | Mic Hi | Speaker/Headphones Out |
RX Audio - Rear J2 Connector
| Pin | Description | Soundcard Connection |
|---|---|---|
| 1 | Ground | Ground |
| 21 | RX Filtered Audio | Mic in |
Rear J2 Connector
| Pin | Description | RIB Connection |
|---|---|---|
| 1 | Ground | Ground |
| 2 | BUS+ | BUS+ |
| 3 | BUS- | BUS- |
| 9 | /BUSY (active-low BUSY) | /BUSY |
- SB9600 RIB
- Bidirectional Soundcard (Speaker & Mic Connections)
J5/J6 Accessory Connector (W-series TIB)
| Pin | Description | Soundcard Connection |
|---|---|---|
| 2 | FLT AUD SHLD | Mic Ground |
| 6 | FLT AUDIO | Mic In |
| 11 | MIC LO | Speaker/Headphones Ground |
| 12 | MIC HI | Speaker/Headphones Out |
| Pin | Description | RIB Connection |
|---|---|---|
| 5 | BUS+ | BUS+ |
| 14 | BUS- | BUS- |
| 21 | BUS SHLD | Ground |
| 23 | BUSY | BUSY |
- SB9600 RIB
- Bidirectional Soundcard (Speaker & Mic Connections)
Bottom DB25 Accessory Connector
| Pin | Description | Soundcard Connection |
|---|---|---|
| 10 | ANALOG GND | Mic & Speaker Ground |
| 11 | FLT AUD OUT | Mic In |
| 13 | MIC IN | Speaker/Headphones Out |
| Pin | Description | RIB Connection |
|---|---|---|
| 4 | DIGITAL GND | Ground |
| 5 | BUSY | /BUSY |
| 6 | BUS+ | BUS+ |
| 18 | BUS- | BUS- |