add Holybro KakuteH7 support

.github/workflows/compile_nuttx.yml

@@ -33,6 +33,7 @@ jobs:
           holybro_can-gps-v1,
           holybro_durandal-v1,
           holybro_kakutef7,
+          holybro_kakuteh7,
           holybro_pix32v5,
           matek_h743-slim,
           modalai_fc-v1,

ROMFS/px4fmu_common/init.d/rc.mc_defaults

@@ -7,7 +7,10 @@
 
 set VEHICLE_TYPE mc
 
-param set-default IMU_GYRO_RATEMAX 800
+if param compare IMU_GYRO_RATEMAX 400
+then
+	param set-default IMU_GYRO_RATEMAX 800
+fi
 
 param set-default NAV_ACC_RAD 2
 

boards/holybro/kakuteh7/bootloader.px4board

@@ -0,0 +1,3 @@
+CONFIG_BOARD_TOOLCHAIN="arm-none-eabi"
+CONFIG_BOARD_ARCHITECTURE="cortex-m7"
+CONFIG_BOARD_ROMFSROOT=""

boards/holybro/kakuteh7/default.px4board

@@ -0,0 +1,92 @@
+CONFIG_BOARD_TOOLCHAIN="arm-none-eabi"
+CONFIG_BOARD_ARCHITECTURE="cortex-m7"
+CONFIG_BOARD_SERIAL_GPS1="/dev/ttyS3"
+CONFIG_BOARD_SERIAL_TEL1="/dev/ttyS0"
+CONFIG_BOARD_SERIAL_TEL2="/dev/ttyS1"
+CONFIG_BOARD_SERIAL_RC="/dev/ttyS4"
+CONFIG_DRIVERS_ADC_BOARD_ADC=y
+CONFIG_COMMON_BAROMETERS=y
+CONFIG_DRIVERS_BATT_SMBUS=y
+CONFIG_DRIVERS_CAMERA_CAPTURE=y
+CONFIG_DRIVERS_CAMERA_TRIGGER=y
+CONFIG_COMMON_DIFFERENTIAL_PRESSURE=y
+CONFIG_COMMON_DISTANCE_SENSOR=y
+CONFIG_DRIVERS_DSHOT=y
+CONFIG_DRIVERS_GPS=y
+CONFIG_DRIVERS_IMU_INVENSENSE_ICM20689=y
+CONFIG_DRIVERS_IMU_INVENSENSE_MPU6000=y
+CONFIG_DRIVERS_OSD=y
+CONFIG_COMMON_LIGHT=y
+CONFIG_COMMON_MAGNETOMETER=y
+CONFIG_COMMON_OPTICAL_FLOW=y
+CONFIG_DRIVERS_POWER_MONITOR_INA226=y
+CONFIG_DRIVERS_PWM_OUT=y
+CONFIG_DRIVERS_PWM_OUT_SIM=y
+CONFIG_DRIVERS_RC_INPUT=y
+CONFIG_DRIVERS_ROBOCLAW=y
+CONFIG_DRIVERS_RPM=y
+CONFIG_DRIVERS_SMART_BATTERY_BATMON=y
+CONFIG_COMMON_TELEMETRY=y
+CONFIG_DRIVERS_TONE_ALARM=y
+CONFIG_MODULES_ATTITUDE_ESTIMATOR_Q=y
+CONFIG_MODULES_AIRSPEED_SELECTOR=y
+CONFIG_MODULES_BATTERY_STATUS=y
+CONFIG_MODULES_CAMERA_FEEDBACK=y
+CONFIG_MODULES_COMMANDER=y
+CONFIG_MODULES_CONTROL_ALLOCATOR=y
+CONFIG_MODULES_DATAMAN=y
+CONFIG_MODULES_EKF2=y
+CONFIG_MODULES_ESC_BATTERY=y
+CONFIG_MODULES_EVENTS=y
+CONFIG_MODULES_FLIGHT_MODE_MANAGER=y
+CONFIG_MODULES_FW_ATT_CONTROL=y
+CONFIG_MODULES_FW_AUTOTUNE_ATTITUDE_CONTROL=y
+CONFIG_MODULES_FW_POS_CONTROL_L1=y
+CONFIG_MODULES_GYRO_CALIBRATION=y
+CONFIG_MODULES_GYRO_FFT=y
+CONFIG_MODULES_LAND_DETECTOR=y
+CONFIG_MODULES_LANDING_TARGET_ESTIMATOR=y
+CONFIG_MODULES_LOAD_MON=y
+CONFIG_MODULES_LOGGER=y
+CONFIG_MODULES_MAG_BIAS_ESTIMATOR=y
+CONFIG_MODULES_MANUAL_CONTROL=y
+CONFIG_MODULES_MAVLINK=y
+CONFIG_MODULES_MC_ATT_CONTROL=y
+CONFIG_MODULES_MC_AUTOTUNE_ATTITUDE_CONTROL=y
+CONFIG_MODULES_MC_HOVER_THRUST_ESTIMATOR=y
+CONFIG_MODULES_MC_POS_CONTROL=y
+CONFIG_MODULES_MC_RATE_CONTROL=y
+CONFIG_MODULES_NAVIGATOR=y
+CONFIG_MODULES_RC_UPDATE=y
+CONFIG_MODULES_ROVER_POS_CONTROL=y
+CONFIG_MODULES_SENSORS=y
+CONFIG_MODULES_SIH=y
+CONFIG_MODULES_TEMPERATURE_COMPENSATION=y
+CONFIG_MODULES_VMOUNT=y
+CONFIG_MODULES_VTOL_ATT_CONTROL=y
+CONFIG_SYSTEMCMDS_BL_UPDATE=y
+CONFIG_SYSTEMCMDS_ACTUATOR_TEST=y
+CONFIG_SYSTEMCMDS_DMESG=y
+CONFIG_SYSTEMCMDS_DUMPFILE=y
+CONFIG_SYSTEMCMDS_GPIO=y
+CONFIG_SYSTEMCMDS_HARDFAULT_LOG=y
+CONFIG_SYSTEMCMDS_I2CDETECT=y
+CONFIG_SYSTEMCMDS_LED_CONTROL=y
+CONFIG_SYSTEMCMDS_MFT=y
+CONFIG_SYSTEMCMDS_MIXER=y
+CONFIG_SYSTEMCMDS_MOTOR_TEST=y
+CONFIG_SYSTEMCMDS_NSHTERM=y
+CONFIG_SYSTEMCMDS_PARAM=y
+CONFIG_SYSTEMCMDS_PERF=y
+CONFIG_SYSTEMCMDS_PWM=y
+CONFIG_SYSTEMCMDS_REBOOT=y
+CONFIG_SYSTEMCMDS_SD_BENCH=y
+CONFIG_SYSTEMCMDS_SD_STRESS=y
+CONFIG_SYSTEMCMDS_SYSTEM_TIME=y
+CONFIG_SYSTEMCMDS_TOP=y
+CONFIG_SYSTEMCMDS_TOPIC_LISTENER=y
+CONFIG_SYSTEMCMDS_TUNE_CONTROL=y
+CONFIG_SYSTEMCMDS_UORB=y
+CONFIG_SYSTEMCMDS_USB_CONNECTED=y
+CONFIG_SYSTEMCMDS_VER=y
+CONFIG_SYSTEMCMDS_WORK_QUEUE=y

boards/holybro/kakuteh7/firmware.prototype

@@ -0,0 +1,13 @@
+{
+    "board_id": 1048,
+    "magic": "PX4FWv1",
+    "description": "Firmware for the KakuteH7 board",
+    "image": "",
+    "build_time": 0,
+    "summary": "KAKUTEH7",
+    "version": "0.1",
+    "image_size": 0,
+    "image_maxsize": 1835008,
+    "git_identity": "",
+    "board_revision": 0
+}

boards/holybro/kakuteh7/init/rc.board_defaults

@@ -0,0 +1,27 @@
+#!/bin/sh
+#
+# board specific defaults
+#------------------------------------------------------------------------------
+
+param set-default BAT1_V_DIV 11.2
+param set-default BAT1_A_PER_V 59.5
+
+# system_power unavailable
+param set-default CBRK_SUPPLY_CHK 894281
+
+# Select the Generic 250 Racer by default
+param set-default SYS_AUTOSTART 4050
+
+# use the Q attitude estimator, it works w/o mag or GPS.
+param set-default SYS_MC_EST_GROUP 3
+param set-default ATT_ACC_COMP 0
+param set-default ATT_W_ACC 0.4000
+param set-default ATT_W_GYRO_BIAS 0.0000
+
+param set-default SYS_HAS_MAG 0
+
+# the startup tune is not great on a binary output buzzer, so disable it
+param set-default CBRK_BUZZER 782090
+
+param set-default IMU_GYRO_RATEMAX 2000
+

boards/holybro/kakuteh7/init/rc.board_extras

@@ -0,0 +1,13 @@
+#!/bin/sh
+#
+# KakuteH7 specific board extras init
+#------------------------------------------------------------------------------
+
+if ! param compare OSD_ATXXXX_CFG 0
+then
+	atxxxx start -s
+fi
+
+# DShot telemetry is always on UART7
+dshot telemetry /dev/ttyS5
+

boards/holybro/kakuteh7/init/rc.board_sensors

@@ -0,0 +1,13 @@
+#!/bin/sh
+#
+# Holybro KakuteH7 specific board sensors init
+#------------------------------------------------------------------------------
+board_adc start
+
+# The default IMU is an ICM20689, but there might also be an MPU6000
+if ! mpu6000 -R 6 -s start
+then
+	icm20689 -R 6 -s start
+fi
+
+bmp280 -X start

boards/holybro/kakuteh7/nuttx-config/bootloader/defconfig

@@ -0,0 +1,93 @@
+#
+# This file is autogenerated: PLEASE DO NOT EDIT IT.
+#
+# You can use "make menuconfig" to make any modifications to the installed .config file.
+# You can then do "make savedefconfig" to generate a new defconfig file that includes your
+# modifications.
+#
+# CONFIG_DEV_CONSOLE is not set
+# CONFIG_DISABLE_PSEUDOFS_OPERATIONS is not set
+# CONFIG_SPI_EXCHANGE is not set
+# CONFIG_STM32H7_SYSCFG is not set
+CONFIG_ARCH="arm"
+CONFIG_ARCH_BOARD_CUSTOM=y
+CONFIG_ARCH_BOARD_CUSTOM_DIR="../../../../boards/holybro/kakuteh7/nuttx-config"
+CONFIG_ARCH_BOARD_CUSTOM_DIR_RELPATH=y
+CONFIG_ARCH_BOARD_CUSTOM_NAME="px4"
+CONFIG_ARCH_CHIP="stm32h7"
+CONFIG_ARCH_CHIP_STM32H743VI=y
+CONFIG_ARCH_CHIP_STM32H7=y
+CONFIG_ARCH_INTERRUPTSTACK=512
+CONFIG_ARMV7M_BASEPRI_WAR=y
+CONFIG_ARMV7M_ICACHE=y
+CONFIG_ARMV7M_MEMCPY=y
+CONFIG_ARMV7M_USEBASEPRI=y
+CONFIG_BOARDCTL_RESET=y
+CONFIG_BOARD_INITTHREAD_PRIORITY=254
+CONFIG_BOARD_LATE_INITIALIZE=y
+CONFIG_BOARD_LOOPSPERMSEC=22114
+CONFIG_BOARD_RESET_ON_ASSERT=2
+CONFIG_C99_BOOL8=y
+CONFIG_CDCACM=y
+CONFIG_CDCACM_IFLOWCONTROL=y
+CONFIG_CDCACM_PRODUCTID=0x004b
+CONFIG_CDCACM_PRODUCTSTR="PX4 BL Holybro KakuteH7"
+CONFIG_CDCACM_RXBUFSIZE=600
+CONFIG_CDCACM_TXBUFSIZE=12000
+CONFIG_CDCACM_VENDORID=0x3162
+CONFIG_CDCACM_VENDORSTR="Holybro"
+CONFIG_CLOCK_MONOTONIC=y
+CONFIG_DEBUG_FULLOPT=y
+CONFIG_DEBUG_SYMBOLS=y
+CONFIG_DEFAULT_SMALL=y
+CONFIG_DISABLE_MQUEUE=y
+CONFIG_DISABLE_PTHREAD=y
+CONFIG_EXPERIMENTAL=y
+CONFIG_FDCLONE_DISABLE=y
+CONFIG_FDCLONE_STDIO=y
+CONFIG_HAVE_CXX=y
+CONFIG_HAVE_CXXINITIALIZE=y
+CONFIG_IDLETHREAD_STACKSIZE=750
+CONFIG_LIBC_FLOATINGPOINT=y
+CONFIG_LIBC_LONG_LONG=y
+CONFIG_LIBC_STRERROR=y
+CONFIG_LIB_BOARDCTL=y
+CONFIG_MEMSET_64BIT=y
+CONFIG_MEMSET_OPTSPEED=y
+CONFIG_PREALLOC_TIMERS=50
+CONFIG_PTHREAD_STACK_MIN=512
+CONFIG_RAM_SIZE=245760
+CONFIG_RAM_START=0x20010000
+CONFIG_RAW_BINARY=y
+CONFIG_SDCLONE_DISABLE=y
+CONFIG_SERIAL_TERMIOS=y
+CONFIG_SIG_DEFAULT=y
+CONFIG_SIG_SIGALRM_ACTION=y
+CONFIG_SIG_SIGUSR1_ACTION=y
+CONFIG_SIG_SIGUSR2_ACTION=y
+CONFIG_SPI=y
+CONFIG_STACK_COLORATION=y
+CONFIG_START_DAY=30
+CONFIG_START_MONTH=11
+CONFIG_STDIO_BUFFER_SIZE=32
+CONFIG_STM32H7_BKPSRAM=y
+CONFIG_STM32H7_DMA1=y
+CONFIG_STM32H7_OTGFS=y
+CONFIG_STM32H7_PROGMEM=y
+CONFIG_STM32H7_SERIAL_DISABLE_REORDERING=y
+CONFIG_STM32H7_TIM1=y
+CONFIG_STM32H7_USART3=y
+CONFIG_SYSTEMTICK_HOOK=y
+CONFIG_SYSTEM_CDCACM=y
+CONFIG_TASK_NAME_SIZE=24
+CONFIG_TTY_SIGINT=y
+CONFIG_TTY_SIGINT_CHAR=0x03
+CONFIG_TTY_SIGTSTP=y
+CONFIG_USART3_RXBUFSIZE=600
+CONFIG_USART3_TXBUFSIZE=300
+CONFIG_USBDEV=y
+CONFIG_USBDEV_BUSPOWERED=y
+CONFIG_USBDEV_MAXPOWER=500
+CONFIG_USEC_PER_TICK=1000
+CONFIG_USERMAIN_STACKSIZE=2944
+CONFIG_USER_ENTRYPOINT="bootloader_main"